[sm=idea.gif] Hello; Does anyone out there know of a company or anyone else that will laser cut parts from a set of plans? I did find one place but they pretty much just do it for large scale planes. It would sure be nice if someone did because there haven't been too many new kits come out lately, mostly ARF's, and I consider myself "Parts cutting challenged". Thanks George.

try precision cut kits they do very good work , and larry is good to work with

Try this.

http://www.gundersonaerodesign.com/

Les

Try [link=http://www.ne-aero.com/page4.html]Northeast Aerodynamics[/link]

I recently purchased a short kit from a guy who uses their service. The quality is outstanding. Nicely selected wood as well.

or you could try akm
http://ak-models.com/
they have a laser cutting service

Here's the link to Precision Cut Kits - owned by Larry Katano - that was previously mentioned. http://www.precisioncutkits.com/

[link]http://www.lazer-works.com[/link]

Eddie is also a reseller of several plan services including RCM. I've had him cut quite a few planes for me and they've always been top quality.

Ken

Thanks a lot guys. I will go to all of those sites. It will be nice if I can get laser cut kits done for me because there are a lot of .40 to .60 size plans out there. There have not been too many new kits come out lately, mostly ARF's. Thanks again guys for the info. Cal

Three is a K-boodle of them listed over at the top in the Scratch building forum.

Simpliest way to save a few set up dollars, is to contact each of the firms noted there, asking if they already have the desired A/C sitting on their hard drive.


Wm.

This guy does super clean work - http://www.laserlizard.com