Setting up Throws Mechanically
02-21-2002, 12:13 PM
#1
Senior Member
Thread Starter
Join Date: Feb 2002
Location: Austin, TX
Posts: 1,894
Likes: 0
Received 0 Likes
on
0 Posts
Setting up Throws Mechanically
I seem to have forgotten how to setup mechanical throws and was hoping someone could aid me here.
Servo arm: hole closest to servo =?
Control horn: hole furthermost from service =?
Servo arm: hole furthermost from servo =?
Control horn: hole closest to service =?
Thanks
Servo arm: hole closest to servo =?
Control horn: hole furthermost from service =?
Servo arm: hole furthermost from servo =?
Control horn: hole closest to service =?
Thanks
02-21-2002, 01:09 PM
#2
Senior Member
My Feedback: (19)
Join Date: Dec 2001
Location: Evansville, IN
Posts: 2,156
Likes: 0
Received 0 Likes
on
0 Posts
Setting up Throws Mechanically
servo arm - close to center less throw out at end more throw.
horn, inside more throw -less torque, outside(farthest out) less throw more torque (pushing power)
horn, inside more throw -less torque, outside(farthest out) less throw more torque (pushing power)
