WING LOAD
 

Hi all! I'm trying to figure wing load for a Byron Beechcraft Baron 58. Does anyone know the formula for this?

RE: WING LOAD
 

Divide the total weight by the wing area.

So if your plane weighed 10# (160oz) and your wing was a total of 780 Sq In:

160/780= .205 oz per sq in

RE: WING LOAD
 

Thanks Mike !

RE: WING LOAD
 

Just as an added note, wing loading is usually stated per square foot so you would need to take the .205 from the above example and multiply it by 144. ;)

RE: WING LOAD
 

Stick Jammer, what is optimal wing loading? I herd it is 16lbs per square foot, is that correct?

RE: WING LOAD
 

There is no universal optimum wing loading. Having too little wing loading is not good, nor obviously, is too much -- sooo optimal wing loading is specific to each aircraft type & use. 16 lbs/sq ft would be very light for a warbird & perhaps too heavy for a park flier.

RE: WING LOAD
 

16#/sq. ft. would be extremely heavy for any model. 16 oz/sq. ft would be light for a .40 size trainer. In .40 size trainer or sport, I try for less than 20 oz/sq. ft. A glider or slow flyer would be much less while a warbird would be more.

RE: WING LOAD
 

Unless you are flying a light weight fun fly plane you will have a hard time getting much under 20 oz/sq-ft. The NexStar trainer from the Tower flier is listed at 722 sq in and 6.5 #. This is 20.75 oz/sq-ft. Most all sport planes will have a higher wing loading than this.

Generally, wing loading is size dependent. Smaller planes need a lighter wing loading to fly well than do larger planes. Sport planes in the .40-.61 size will be in the 20's. Over 30 and they are going to start feeling heavy. .91-1.20 size planes will go into the 30's. The bigger planes will tolerate higher values. Large warbirds can be in the 40's and fly OK. In a .46 sized plane, this would be a crash waiting to happen.

A math short cut is to divide pounds weight by wing area in square inches, then multiply this result by 2304.

RE: WING LOAD
 

My Thunder Tiger Stick, stock, with a Thunder Tiger Pro46, and Futaba radio was under 5 1/2 pounds for a wing loading of 17 oz/sq ft. The trainer was slightly less than that. My Balsa USA Stick 40+ with a Thunder Tiger GP42 has a wing loading of just under 20 oz/sq ft because of the smaller wing area. The Sig Citabria has a wing loading of 20.4 oz/sq ft. These are what my statement is based on. From my experience, most .40 size trainers should come out between 5 1/2 and 6 pounds dry.

RE: WING LOAD
 

I'm new to wing loading calculation, I've listened to many opinions, seems I got it wrong. I think I've got it now; Divide the wing area by 144 to convert square inches to square feet, then divide the weight ( ounces ) by the wing area ( in square feet )= ounces per square feet.

RE: WING LOAD
 

Did I really say lbs? Sorry folks it's the little ones (oz).

RE: WING LOAD
 

zoro,
You are correct.

RE: WING LOAD
 

http://www.gsal.org/tools/Wing_Laoding.htm