Internal Linkage - post pics of your setup
 

I am working on a Porter and am doing internal linkages on the elevator and rudder. Just hoping some of you can post some pics of how you did your internal linkage setups - doesnt have to be a Porter.

Thanks
tks1

RE: Internal Linkage - post pics of your setup
 

All kinds of ways...
http://www.angelfire.com/indie/aeros...rvoLayouts.htm

RE: Internal Linkage - post pics of your setup
 

Thanks Tall Paul

tks1

RE: Internal Linkage - post pics of your setup
 

Here's the inside of my TopFlite Spitfire.
One of the things that I did was to make covers over the servos to prevent wires and tubes from getting caught up in the arms and rods. They were made from mylar. I also labled the wires by channel. The first two show the receiver and battery installed. They were removed in the other three photos. The servos shown are, gear, throttle, elevator and rudder. The trays were made from lite ply.

Scott

RE: Internal Linkage - post pics of your setup
 

Thanks Scott. You dont have a lot of space in there :D

tks1