I dont have a 'prime' button on my hyper, could someone list the steps i need to take in order to prime it?

I've read..
loosen the glow plug and start up the starter box for a sec.

Is this just to get some fuel through the pipes?

I thought i'd ask you guys first as you all seem very helpfully and know what your talking about

to prime the engine, put your finger over the exhast tip and pull the pullstart. watch the fuel go through the lines till it hits the carb then stop, put the glow inginter on and start your engine....

You can also pull the pressure line off the pipe and blow into it. When you see the fuel enter the carb, stop blowing (nitro tastes like crap)!