Hi

Due to my ham fisted approach I have managed to round of one of the hex bolts attaching my engine mounting plat to the chassis, due to using wrong size allan key and giving it too much when doing up

Is my only option now to drill the head off and take the plat off and drill the remains out or is there another way

Thanks
Mike

take a dremel and cut a straight line in to it. then use a screw driver.

Thanks for that I will give that ago

Thanks
Mike

Mike

You should stop playing around with your nuts. I've told you before about this. [sm=lol.gif][sm=lol.gif]

Well Neil S**t rolls down hill, and I got some.[:@][:'(][&:][sm=drowning.gif]

In me nuts that is, should never have taken me engine out when it was all covered in muck

Mike

Bet thats the last time you will try and take your mini hex bolts out with a air impact wrench [sm=punching.gif][sm=punching.gif]

I dare not look at the mess of my car yet. Think mine may be even dirtier than yours.


Neil.

"It always rolls down onto me."

That reminds me, the Cheese chase is on soon, better get my entry in.

I want to go cheese rolling too!!
I just cant aford to have time off work with broken bones. lol

Damn! That must have hurt....[sm=spinnyeyes.gif]
Think mabie you should post that in a medical forum & not an RC one....[sm=lol.gif]

I got a solution for you Mike

Buy an inferno, I know u wanna.

[&:][&:][&:]

I hate the inferno, they come apart[:-][:-][:-] well yours does any how