Ok Im about to order my OS RG and was wondering what pipe I should get with it? I guess Im just looking for a good all around pipe for under 100 bucks. Thanks

JP-1 or JP-2.

The RG has very good bottom end to start with so I would get the JP-2 for it. It will give it a few more rpms on the top.
I always run a 13t clutch bell too.

I run an 086 on mine, no complaints here

JP-1 if you need more bottom end and JP-2 for top end

I used a JP-1 with my mill (actually selling the pipe now) and it worked great. We run on a tight technical track where I'm from. The 086 is also a great pipe.

the Jp-2 works very well with the RG

got that pipe for sale? Could you give me an email including a pic and cost, [email protected]

Run a 063, get a pipe that enhances what the motor does best (that is a general rule of thumb). Thus a low end(more torque) pipe for a bottom end motor.

I've ran a few differnet pipes, the JP-2 is by far the best pipe on it.

Oh a fellow desert rat! Well when the motor and pipe get here Ill have to buy a case of beer and have you break it in for me.