Electronics Freak out when engine is touched with metal object?
#1
Thread Starter
Junior Member
Joined: May 2006
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
From: Cascade, WI
I run a Hyper 8 with the novak synthesized system in my M8 radio. What causes the electronics in the car to get all freaked out when I put my glow starter on and/or I touch a metal object to the cylinder head? Other then this issue the system works fine. I just put in a new novak synthesized receiver as my old one was doing some funny things when the engine was at wide open throttle due to the vibrations.
#6
Senior Member
Joined: Sep 2005
Posts: 1,854
Likes: 0
Received 0 Likes
on
0 Posts
From: Dead Center,
Check all the wires, servos and the switch wires. I had a switch wire that was worn (I think it got pinched by the reciever cover) and the same thing happened. Not saying its the switch wire, but my bet is one is worn thus given you the glitches...GL
#8
Senior Member
Joined: Oct 2005
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
From: San Francisco,
CA
Happens to me even if I touch the head with a metal object while the engine is off, but it causes no interference while driving, so it doesn't bother me. And I have an AM radio.



