I have cen matrix rtr . I pulled the stock cen motor and put nova rossi 21bf and used the stock flywheel and clutch bell. The clutch bell is scraping on the chassis. I noticed the nova engine sits lower. What would you guys suggest for motor mount replacement so i can get this fired up with clearance.
thanx

Can you not just use a set of spacers? If you cant get hold of any use washers but you should be able to get spacers from most places. like [link=http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXMW33&P=7]these[/link]

ya i tried spacers but if i do that the starter box wheel would not reach the flywheel properly.

hmm, i put the exact same engine into the exact same buggy and had no clearance issues what so ever.