feguez

I have the .32 axial motor with head button turbo in the buggy Ofna 9.5 pro, I tried to see what are the best exhaust systems but I can not decide .... Here are the options I put my ... if you know of something better please let me know ... thanks

jmaxey51

i highly recommend the Dynamite 053 pipe, its is almost the exact same as the JP3 but it is a good bit cheaper. i have both the JP3 and Dynamite 053 and i hardly ever use the JP3 and all i run is the 053 on all of my engines. i only run the JP3 on my back up engine.

kojak61

+1 on the dyno 053. With that motor you need a High end pipe. It has nothing but bottom.

Hoese37

the high end pipe would be the 086HT.

djzachtyler

My Feedback: (4)

+100 the Dynamite 053 is awesome for this mill as it compliments this engines performance characteristics quite well. The Axial .32 is a low to mid powerband engine meaning it is bewst ayt lower and mid range RPMs and generates most of it's power in that range, when couple with an 053 pipe, which is engineered for mid range powerband performance you will ahve yourself quite a torque monster of a combo... Just be careful as it can wreack havoc with the drive train if you are too hard on and off throttle

bluesilver

How do these motor respond to modifying?
Was going to make a twin engine monster truck and get two of them modified.