choosing a prop for a brushless motor
#1
Junior Member
Thread Starter
Join Date: Jan 2018
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
choosing a prop for a brushless motor
Hey,
I was gifted a brush less 2430 8200kv motor and i have a 4:1 pulley gear that i hope to run off a 30A esc and 2S lipo to push a simple airboat made of styrofoam. the only part im not sure of is the propeller. With the gearing the no load rpm should be about 15,100 rpm. any help picking an appropriate propeller for this setup would be greatly appreciated.
Regards,
RCypher
I was gifted a brush less 2430 8200kv motor and i have a 4:1 pulley gear that i hope to run off a 30A esc and 2S lipo to push a simple airboat made of styrofoam. the only part im not sure of is the propeller. With the gearing the no load rpm should be about 15,100 rpm. any help picking an appropriate propeller for this setup would be greatly appreciated.
Regards,
RCypher