custom servo driven TRIMTABS + VIDEO CLIP
#1
Junior Member
Thread Starter
Join Date: Mar 2003
Location: miami,
FL
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
custom servo driven TRIMTABS + VIDEO CLIP
--------------------------------------------------------------------------------
took me a while to figure if I was going to make it a screw type or push rod.I figure I can get some good leverage with the horns so I set it up with push rods.should also give me faster response .both are controled individually through 2 channels on a nautical commander remote.these were originally thread adjustment tabs.(the type you have to undo and turn to drop or raise on the dock.....NO MORE OF THIS NONSENSE..
I have a video clip of them moving...if anyone is interested in posting this please send me a message..
[email protected]
..I dont want to waste time starting up a web page to upload videos.
check out my photo gallery..
+++ VIDEO CLIPhttp://home.mchsi.com/~terboinc/trimtabs.AVI
took me a while to figure if I was going to make it a screw type or push rod.I figure I can get some good leverage with the horns so I set it up with push rods.should also give me faster response .both are controled individually through 2 channels on a nautical commander remote.these were originally thread adjustment tabs.(the type you have to undo and turn to drop or raise on the dock.....NO MORE OF THIS NONSENSE..
I have a video clip of them moving...if anyone is interested in posting this please send me a message..
[email protected]
..I dont want to waste time starting up a web page to upload videos.
check out my photo gallery..
+++ VIDEO CLIPhttp://home.mchsi.com/~terboinc/trimtabs.AVI