Flat Pattern
10-14-2005 | 07:46 PM
#1
Thread Starter
Senior Member
My Feedback: (1)
Flat Pattern
Flat Pattern
I want to make up sides and a bottom for a boat using 1/32 plywood. It is flexible enough such that it can be twisted and glued into place. Before going too far, I however want to make up a flat pattern.
Does anyone know of a source or system to make up a twisted flat pattern for three view drawings? I am looking for a graphical approach to this, much as would come out of a high school drafting book for bending sheet metal.
I also do not want to cut up numerous pieces of paper to begin with. I have to cut up all of the basic plywood at one time on a jig-saw, so cannot go back and forth with paper patterns.
Wm.
I want to make up sides and a bottom for a boat using 1/32 plywood. It is flexible enough such that it can be twisted and glued into place. Before going too far, I however want to make up a flat pattern.
Does anyone know of a source or system to make up a twisted flat pattern for three view drawings? I am looking for a graphical approach to this, much as would come out of a high school drafting book for bending sheet metal.
I also do not want to cut up numerous pieces of paper to begin with. I have to cut up all of the basic plywood at one time on a jig-saw, so cannot go back and forth with paper patterns.
Wm.
