I don't have my Hyper 7 PBS yet, but I will on Wednesday. I assume the screws take metric hex wrenches. What sizes do I need to get?

Are there any other parts I should stock up on? Maybe a certain bearing that always seems to go out?

Thanks.

Roy

I am not sure about the Hyper, but I just got the new 9.5 Violator and I have already messed up my 1.5mm and 2mm Ball end hex keys. Also you will need a 2.5 hex, and make sure that you have a metric 5.5mm wrench for your standoffs.

Dynamite makes some really good and inexpensive wrenches. For the PBS, you'll want a 2.0, 2.5 and a 3.0. They will run you roughly 7.00 each.

http://h1070187.hobbyshopnow.com/pro...p?prod=DYN2901

http://h1070187.hobbyshopnow.com/pro...p?prod=DYN2902

http://h1070187.hobbyshopnow.com/pro...p?prod=DYN2903

do those tools strip cuz den if they do them its all bad. i use the L type ones there not all that comfortable to use but they last longer cuz if it strips you could juss shave it off

No they don't strip. They are hardened steel. The allen wrenches you are using will strip the heads out in no time.

I just bought the OS wrench set from Tower it was $30 american dollars. Came with long glow plug wrench and 3.0 - 2.5 - 2.0 - 1.5 hex wrenches. Pretty nice set.