Accelleration Problem
#1
Member
Thread Starter
Join Date: Jan 2008
Location: dubai, UNITED ARAB EMIRATES
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
Accelleration Problem
Hi All, Itas Benn A Whils Scince I Were Last On Here..
Jus Vefor I went On Holiday, I decided To Take My Savage X 4.6 to the track..
After a few lap i landed upsed doen on a jump
i flipped it back over.. fine for a few laps..
untill i drove it in to check everythin was alright fuel wise...
topped it up
went to drive off, but my truck just sat there and revved.., then it put itself into 2nd gear and wizzed off
i didnt hace time to check anything at the track
so upon returning home from my holidays i checked my truck over
diffs-fine
gearbox-fine
clutch bell-fine
clutch shoes-fine
i oilded up the diffs
cleaned the tin side of the cb with petrol, and did the same with the clutch shoes..
they are drying now..
i went to check the hardend spur gear and found it warped
no i no a hardernd spur ger shouldent warp.. but has anyone else had the same problem?
after checking the whole truck over, ive still got the same problem
any ideas what else it could be?
anything else i should check?
because of the warped spur, im going to but a new one.
At the moment my mesh is 47-16 i think, what is the best mesh for wheelying?
thanks
adzey
Jus Vefor I went On Holiday, I decided To Take My Savage X 4.6 to the track..
After a few lap i landed upsed doen on a jump
i flipped it back over.. fine for a few laps..
untill i drove it in to check everythin was alright fuel wise...
topped it up
went to drive off, but my truck just sat there and revved.., then it put itself into 2nd gear and wizzed off
i didnt hace time to check anything at the track
so upon returning home from my holidays i checked my truck over
diffs-fine
gearbox-fine
clutch bell-fine
clutch shoes-fine
i oilded up the diffs
cleaned the tin side of the cb with petrol, and did the same with the clutch shoes..
they are drying now..
i went to check the hardend spur gear and found it warped
no i no a hardernd spur ger shouldent warp.. but has anyone else had the same problem?
after checking the whole truck over, ive still got the same problem
any ideas what else it could be?
anything else i should check?
because of the warped spur, im going to but a new one.
At the moment my mesh is 47-16 i think, what is the best mesh for wheelying?
thanks
adzey