suggestions for motors
#1
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Nov 2007
Location: phoenix,
AZ
Posts: 371
Likes: 0
Received 0 Likes
on
0 Posts
suggestions for motors
hey guys, my esc is rated to 15t and i will be running a standard 6 cell nimh. i was wondering if u guys had any suggestions for a motor to upgrade to. i wanted to keep it around 30 dollars and so far i am considering this:
[link]http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXJAK2&P=V[/link]
also, does bearings make a huge difference? i dont see a difference in rpm, but what else does it do?
[link]http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXJAK2&P=V[/link]
also, does bearings make a huge difference? i dont see a difference in rpm, but what else does it do?
#3
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Nov 2007
Location: phoenix,
AZ
Posts: 371
Likes: 0
Received 0 Likes
on
0 Posts
RE: suggestions for motors
k. what do u think of the ball bearing version of this motor. i think that it is a good choice because it goes up to 9.6 volt and it has a descent rpm.
#4
Senior Member
RE: suggestions for motors
ORIGINAL: yahman1254
k. what do u think of the ball bearing version of this motor. i think that it is a good choice because it goes up to 9.6 volt and it has a descent rpm.
k. what do u think of the ball bearing version of this motor. i think that it is a good choice because it goes up to 9.6 volt and it has a descent rpm.
Maybe I should ask you this question? Are you using it in car/truck?? what are you using it for?? Racing? Bashing? Drifting..
#5
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Nov 2007
Location: phoenix,
AZ
Posts: 371
Likes: 0
Received 0 Likes
on
0 Posts
RE: suggestions for motors
oh, i am using it for bashing in front of my house in an on-road car. the car will either go down the touring car line or drifting when i start racing at the track.