the one way bearing in my pull start is no longer just moving in one direction...I'm assuming that its because of excess fuel leaking down into that particular area of the block and I need to take it apart and give it a good cleaning. also, a good funny story: I was having trouble priming my engine after quite a long time sitting without use. I tried the normal finger over the stinger prime, but it wasn't working. SO I thought maybe my tank wasn't sealing well. I popped the line off the engine and blew into it while holding the exhaust side line closed...I blew too hard and I guess over pressurized the tank. Well, I got a biiig mouth full of nitro fuel. I decided at that point that it would have been better to drain the fuel first lol

Try cleaning it out with some wd40 (one way) and I guess you had good pressure in the tank huh?

lol I did have good pressure in the tank. I think I have a pin hole in the exhaust side line? maybe