ford with a Chevy motor
06-30-2008 | 02:17 PM
#1
Thread Starter
Senior Member
Joined: Nov 2007
Posts: 314
Likes: 0
Received 0 Likes
on
0 Posts
From: benicia,
CA
ford with a Chevy motor
my HPI motor was giving me trouble so i decided to put my jato 3.3 motor in it and it works
this is a HPI RS4 EVO chassis
all i did was grind the HPI clutch bell, a bit and it works, now i just have to buy a roro start to finish the deal, one problem for those who might try this, you must take the brake lever off, because it will engage if you gas it, this only applies to a slide traxxas carb though
hope you guys like it i sure do, cant wait to run this
here it is
this is a HPI RS4 EVO chassis
all i did was grind the HPI clutch bell, a bit and it works, now i just have to buy a roro start to finish the deal, one problem for those who might try this, you must take the brake lever off, because it will engage if you gas it, this only applies to a slide traxxas carb though
hope you guys like it i sure do, cant wait to run this
here it is
