Reflex XTR and Futaba FF7 (mini plug)
06-04-2004 | 07:31 AM
#1
Thread Starter
Member
Joined: May 2004
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
From: London, UNITED KINGDOM
Reflex XTR and Futaba FF7 (mini plug)
Anyone got an using the above setup?
On the reflex page it does not seem to list an interface for the FF7 (the mini square lead type). Is this type the same as on the Futaba 9 series does anyone know?
If not, am I expected to just make / purchase a converter cable to get this working (and order the 6pin DIN old style Futaba interface) ?
Any pointers greatly appreciated.
On the reflex page it does not seem to list an interface for the FF7 (the mini square lead type). Is this type the same as on the Futaba 9 series does anyone know?
If not, am I expected to just make / purchase a converter cable to get this working (and order the 6pin DIN old style Futaba interface) ?
Any pointers greatly appreciated.
06-05-2004 | 05:21 PM
#2
Member
Joined: Jul 2003
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
From: Scotland, UNITED KINGDOM
RE: Reflex XTR and Futaba FF7 (mini plug)
It is the same plug as the futaba 9c m8. You need to get the JR connection i think it is and then get an additional lead from it to the square plug. My XTR came with the round DIN plug and i had to get it swapped.
06-06-2004 | 05:22 AM
#3
Junior Member
Joined: Jun 2004
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
From: , UNITED KINGDOM
RE: Reflex XTR and Futaba FF7 (mini plug)
Rather than but the proper lead you could always just buy the connector from here....
http://www.customelectronics.co.uk/
and make your own..........
only £3.75 and a bit of work to do it.
http://www.customelectronics.co.uk/
and make your own..........
only £3.75 and a bit of work to do it.
Depends who you have making the lead eh? LOL
