Reflex XTR interface cable
02-03-2005 | 09:27 PM
#3
Senior Member
My Feedback: (51)
Joined: Jul 2002
Posts: 5,833
Likes: 0
Received 0 Likes
on
0 Posts
From: Ashland, KY
RE: Reflex XTR interface cable
You can't buy just the cable... that's what allows you to run the software, so if you need an additional one for some reason, you need to purchase another full copy.
02-03-2005 | 09:29 PM
#4
Moderator
My Feedback: (58)
RE: Reflex XTR interface cable
Will, the interface cable for XTR is not sold separately as there is a copy protection code built into it. The cable only comes with the original disk. The same thing applies to other major commercial sims like AFP and RF. Hope this helps
02-03-2005 | 09:38 PM
#6
Thread Starter
Member
Joined: Nov 2003
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
From: .,
OH
RE: Reflex XTR interface cable
Well actually... http://www.reflex-sim.dyndns.org/ref...hp?cPath=27_34 But i dont want to order it from germany.
02-03-2005 | 09:59 PM
#9
Senior Member
My Feedback: (51)
Joined: Jul 2002
Posts: 5,833
Likes: 0
Received 0 Likes
on
0 Posts
From: Ashland, KY
RE: Reflex XTR interface cable
What radio do you need to hook up to your cable?
The one's that you can get from AeroflyPro.com are the same... They plug into the "JR" port on the cable and convert it to Futaba 9C, etc...
The one's that you can get from AeroflyPro.com are the same... They plug into the "JR" port on the cable and convert it to Futaba 9C, etc...
02-03-2005 | 10:34 PM
#11
Senior Member
My Feedback: (51)
Joined: Jul 2002
Posts: 5,833
Likes: 0
Received 0 Likes
on
0 Posts
From: Ashland, KY
RE: Reflex XTR interface cable
Yeah then... the one OMP sells for AFPD will work fine.
I made my own from a trainer cable. Cut it in half.
Two wires get shorted (that turns the radio on when the cable is plugged in and two other wires are the data lines)
I made my own from a trainer cable. Cut it in half.
Two wires get shorted (that turns the radio on when the cable is plugged in and two other wires are the data lines)
