8103 and G2
12-04-2002 | 02:09 AM
#1
Thread Starter
Senior Member
My Feedback: (2)
Joined: Jun 2002
Posts: 180
Likes: 0
Received 0 Likes
on
0 Posts
From: St. Cloud, FL
8103 and G2
Im having problems getting my 8103 to work with G2. In DCS mode. I fly helis and cant get idle up switch to work. When I go to page to check servo operation it seems to be working fine. When I set idle up
The servos work on the graph just like they should, but when I try to fly heli. The pitch changes but the engine speed doesnt go with the settings in the radio. Throttle hold switch is working fine. Please help. I know it can be done I had it working before but I down loaded update for website and lost it all. I cant get the radio to work at all with the new version so I relaoded my old version.
The servos work on the graph just like they should, but when I try to fly heli. The pitch changes but the engine speed doesnt go with the settings in the radio. Throttle hold switch is working fine. Please help. I know it can be done I had it working before but I down loaded update for website and lost it all. I cant get the radio to work at all with the new version so I relaoded my old version.
12-20-2002 | 05:55 AM
#2
Member
Joined: Nov 2002
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
From: Kuala Lumpur, MALAYSIA
8103 and G2
I have got my 8130 to work with G2. Not a probelm, just access the controller calibration menu and calibrate your transmitter interface.
Dont do any mixing in your transmitter, just leave it in software radio.
This should work. The only thing is that the Auto-rotation switch is on the opposite side on the 8130.
Good Luck
Dont do any mixing in your transmitter, just leave it in software radio.
This should work. The only thing is that the Auto-rotation switch is on the opposite side on the 8130.
Good Luck
