Funcopter Tail problem
08-11-2011 | 11:44 PM
#1
Thread Starter
Junior Member
Joined: Apr 2005
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
From: StorvretaUppland, SWEDEN
Funcopter Tail problem
Hi,
I'm a total beginner at helicopter flying although i'm getting the hang of it.
I have a tailproblem with my MPX funcopter, after replacing a broken tailboom and the gears, i have a wierd "clicking" sound in the rear gearbox when i put some load on the tailrotor. First i thought it was the gears that was too loosely meshed but it is not. and you cannot do wrong with mounting it.
[link=http://www.youtube.com/watch?v=onvab05SLGc]Funcopter, Flying by rookie[/link]
I'm a total beginner at helicopter flying although i'm getting the hang of it.
I have a tailproblem with my MPX funcopter, after replacing a broken tailboom and the gears, i have a wierd "clicking" sound in the rear gearbox when i put some load on the tailrotor. First i thought it was the gears that was too loosely meshed but it is not. and you cannot do wrong with mounting it.
[link=http://www.youtube.com/watch?v=onvab05SLGc]Funcopter, Flying by rookie[/link]
08-12-2011 | 10:09 AM
#2
Member
Joined: Jun 2009
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
From: Moreno Valley, CA
RE: Funcopter Tail problem
make sure all your grub screws are tight. also make sure item 109 page 22 is secure to item 28 page 21 [link=http://www.funcoptermods.com/Installation_Page/Installation_Page.html]manual here[/link]
