Co-Pilot problems
08-27-2003 | 09:24 PM
#1
Thread Starter
Junior Member
Joined: Aug 2003
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
From: Kingston, NY
Co-Pilot problems
I have the Co-Pilot installed in my R-30 and have the servo buffer in-line with the aileron servo as per FMA's instructions while using a Futaba PCM Receiver.
The problem is that just after left/right, or for/aft cyclic the servos are still jumping. Then with no input the servos still jitter. I have tried connecting other servos and the problem is still there. plus the receiver and crystals are brand new.
The servos are analogue and I am running a GY401/9253 comb. for the tail. Can the digital servo cause this glittering. It makes it scary at take off and landing.
Please reply?
The problem is that just after left/right, or for/aft cyclic the servos are still jumping. Then with no input the servos still jitter. I have tried connecting other servos and the problem is still there. plus the receiver and crystals are brand new.
The servos are analogue and I am running a GY401/9253 comb. for the tail. Can the digital servo cause this glittering. It makes it scary at take off and landing.
Please reply?
08-27-2003 | 09:54 PM
#2
Senior Member
Joined: May 2003
Posts: 585
Likes: 0
Received 0 Likes
on
0 Posts
From: Charlestown, IN
Co-Pilot problems
The below thread is on co-pilot.
Warlock is a ace on the co-pilot.
Your question might be answered in that thread.
Just click on warlock below an read.
Warlock]
Warlock is a ace on the co-pilot.
Your question might be answered in that thread.
Just click on warlock below an read.
Warlock]
