Hello; Has anyone out there installed the Co-Pilot II on their helicopter? I have programed the "Quick Setup" into the IRNet programmer but when I try to set up The "on-off switch programming" to shut the co-pilot off, I get to the part where it says "Move switch to the off position" I move the two way switch to the off position and I get a message that says "does not move enough" on the programmer screen!!! Can anyone tell me if I am missing something in the setup for the on-off program, or is there a site I can go to to show me how to set up the on-off switch program properly. Any help would be appreciated from anyone that has done this programing on the Co-Pilot II. Thanks again. George.