Trim help
#1
Junior Member
Thread Starter
Join Date: Jan 2021
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Trim help
Hi guys. Sorry firstly I’m new and learning so please go easy lol
Trying to do a trim setup with my dx6 and 200 srx. Been seeing videos with the original dx but not the spectrum 6 and it’s not working as per the videos
Can someone kindly direct me to a setup please, tried searching but unsuccessful using the search in here.
Had a bump and now trying to get it flying smooth after being unstable.
See video if it loads of possible serve issue. In beginner mode doesn’t seem to recenter at all ☹️
Can’t upload a video till I have 10 posts
Thanks
Trying to do a trim setup with my dx6 and 200 srx. Been seeing videos with the original dx but not the spectrum 6 and it’s not working as per the videos
Can someone kindly direct me to a setup please, tried searching but unsuccessful using the search in here.
Had a bump and now trying to get it flying smooth after being unstable.
See video if it loads of possible serve issue. In beginner mode doesn’t seem to recenter at all ☹️
Can’t upload a video till I have 10 posts
Thanks
#2
Senior Member
My Feedback: (2)
Join Date: Apr 2020
Location: Metro Atlanta GA, USA
Posts: 381
Likes: 0
Received 32 Likes
on
28 Posts
Sorry that I'm not any help with the specifics of the problem you are facing. If you haven't done so already, you could also post this thread on HeliFreak
The help I have gotten there for my Blade 230S was and is vastly more useful than I have gotten here (before I gave up trying here). No offense intended, RCU.
The help I have gotten there for my Blade 230S was and is vastly more useful than I have gotten here (before I gave up trying here). No offense intended, RCU.
#3
Junior Member
Thread Starter
Join Date: Jan 2021
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Thank you. Have been there but very quiet.
Been doing some work and it appears that I have a faulty receiver with an intermittent fault.
Carrying out the servo neutral test only one servo does the test, other one doesn’t do anything, swap them over and it does so it’s pushing me to that as an issue.
Been doing some work and it appears that I have a faulty receiver with an intermittent fault.
Carrying out the servo neutral test only one servo does the test, other one doesn’t do anything, swap them over and it does so it’s pushing me to that as an issue.