Go Back  RCU Forums > RC Helicopters > RC Helicopter Beginners Forum
Reload this Page >

Honeybee 2 ... 1st r/c heli...reciever problems

Community
Search
Notices
RC Helicopter Beginners Forum If you are a beginner or "newbie" to RC heli's feel free to post your questions right here in the rc heli beginner forum.

Honeybee 2 ... 1st r/c heli...reciever problems

Thread Tools
 
Search this Thread
 
Old 12-21-2004, 06:42 PM
  #1  
mattx13
Junior Member
Thread Starter
 
Join Date: Dec 2004
Location: , NEW ZEALAND
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Default Honeybee 2 ... 1st r/c heli...reciever problems

Hi... I wait for the green light on the reciever to glow then start to feed it a little power...at about half throttle it starts to miss a little, then the light flashes red and the reciever shuts down. After a few seconds it go's through its start up proceedure again.... when the light is solid green I try again yet the problem repeats.Interference maybe??
Any ideas.
Old 12-22-2004, 09:44 AM
  #2  
tanasit
Senior Member
 
Join Date: Feb 2003
Location: Philadelphia, PA
Posts: 281
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Honeybee 2 ... 1st r/c heli...reciever problems

Make sure the crystal on the TX is fully seated.
Old 12-22-2004, 07:37 PM
  #3  
loadthis
Member
My Feedback: (3)
 
loadthis's Avatar
 
Join Date: Dec 2004
Location: Fort Walton Beach, FL
Posts: 89
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Honeybee 2 ... 1st r/c heli...reciever problems

Sounds almost like a loose connection in the battery. The vibrations when starting up may cause the glitch. ???

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.