Servo's go to which channels on the 4-1?
#1
Junior Member
Thread Starter
Join Date: Mar 2006
Location: Tauranaga, NEW ZEALAND
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Servo's go to which channels on the 4-1?
So i've mentioned that i crashed the helicopter i brought and that it was bad.
But thats ok! my new Parts arrived today! yay!
so, i installed the new 4-1 YAY!
I matched the model #'s up on the 6ch receiver and Mixer/Speed/Gyro, the 6ch receiver S/N:ER635B is a match to the old one i pulled from the Helicopter! the Mixer/Speed/Gyro is EM220A and the old one i pull said "EM220B"
I've email the company that i brought the helicopter from, now im just waiting to hear back from them.
Can anyone tell me the differnce between the Mixer/Speed/Gyro's
Also, can some help me with connecting up the Servo's, which servo goes to which channel output?
Thanks
-Gremlin-
Ohh, the helicopter is an (ESky HoneyBee CP2 E005)
-Gremlin-
But thats ok! my new Parts arrived today! yay!
so, i installed the new 4-1 YAY!
I matched the model #'s up on the 6ch receiver and Mixer/Speed/Gyro, the 6ch receiver S/N:ER635B is a match to the old one i pulled from the Helicopter! the Mixer/Speed/Gyro is EM220A and the old one i pull said "EM220B"
I've email the company that i brought the helicopter from, now im just waiting to hear back from them.
Can anyone tell me the differnce between the Mixer/Speed/Gyro's
Also, can some help me with connecting up the Servo's, which servo goes to which channel output?
Thanks
-Gremlin-
Ohh, the helicopter is an (ESky HoneyBee CP2 E005)
-Gremlin-
#2
Senior Member
Join Date: Sep 2002
Location: Somewhere in the Adirondacks,
NY
Posts: 215
Likes: 0
Received 0 Likes
on
0 Posts
RE: Servo's go to which channels on the 4-1?
The two back servos go to chn 1and 6 and the front one goes chn2. When looking down at the heli and the tail pointing at you left rear servo goes to chn 6 and the right one does to chn 1 and the front one ofcourse goes to chn 2.