HI GOOD NIGHT ALL, IM A NEWB I'VE RECENTLY PURCHASED A WALKERA #22E MODEL, WAS THAT A GOOD CHOICE IS WALKERA ONE OF THE PRIMIER MANUFACTURERS OF HELI'S. IVE ONLY GOTTEN IT OF THE GROUND ABOUT 4 FT. THEM SLAM IT HARD ON THE FLOOR, AFTER THAT I'VE ONLY MANAGED A COUPLE INCHES. NOW I'VE BROKEN THE BLADE HOLDER, DAMAGED THE BLADE AND ONE OF THE BALL LINK. IS THE HELIS THAT HARD TO FLY, WAS THE SETTING ON THE TRANSMITTER INCORRECT. IM NEW SO MY KNOWLEDGE IS QUITE LIMITED, WHAT DOES THE GEAR SWITCH, PLT AND THE PIT KNOB FOR AND DO. WHEN I REPLACE THE PARTS WHAT ADJUSTMENTS SHOULD I MAKE TO RESTORE THE FACTURY SETTTING SO I CAN FLY THE HELI. IM ALSO COMSIDERING TO BUY A TRAINING GEAR AND A SIMULATOR, IS THAT THE RIGHT CHOICE SINCE IM NEW OR CAN I LEARN TO CONTROL THE HELI WITHOUT THEM. WHEN I EVEN APPLY FULL TROTTLE IT JUST BARELY GET OFF THE GROUND. ITS DRIVING ME NUTS AT TIMES.

If I were you I'd check out the [link=http://www.rcuniverse.com/forum/forumid_405/tt.htm]Walkera sub-forum[/link] and specifically [link=http://www.rcuniverse.com/forum/m_3722641/tm.htm]this[/link] thread. Also writing in caps are harder to read and people may just go right by your post.

Heliko thnaxs for your advice, i rreally appreciate it.

Anytime