How do you fit 12mm blade in 14mm holder
#2
Senior Member
Join Date: Jun 2007
Location: covington,
GA
Posts: 738
Likes: 0
Received 0 Likes
on
0 Posts
RE: How do you fit 12mm blade in 14mm holder
you can use some spacers. What heli are you working with?
Dubro has some nylon washers, take your blades and a grip up to the hobby shop and try a few, get it as close as possible. A little on the small side is better than stretching the grip and having the blade too tight. Not overly small, just what can be taken up when you tighten up the bolt.
Dubro has some nylon washers, take your blades and a grip up to the hobby shop and try a few, get it as close as possible. A little on the small side is better than stretching the grip and having the blade too tight. Not overly small, just what can be taken up when you tighten up the bolt.
#4
Thread Starter
My Feedback: (119)
Join Date: May 2004
Location: Ft. Wayne,
IN
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
RE: How do you fit 12mm blade in 14mm holder
The Century 600mm blades came with the plastic re-inforcements but that only made them 12MM thick. The JR Venture 50 takes 14Mm thick blades. I need to find shims to fill the void.
BBB
BBB
#9
Senior Member
My Feedback: (2)
Join Date: Jul 2005
Location: gretna,
MB, CANADA
Posts: 506
Likes: 0
Received 0 Likes
on
0 Posts
RE: How do you fit 12mm blade in 14mm holder
ORIGINAL: BIG BAD BOB
Thanks, I'll try that, I'm not cheap, just thrifty!!!
Thanks, I'll try that, I'm not cheap, just thrifty!!!
HAHAHAAhhhhaaaa....
over here its not about being cheap, its about living in the middle of no-where...... ;-)