jimbo56

I got the cx 9 months ago and have had nothing but problems and not enough time to learn and fix plus at a complete loss for what to do next anyway. first few times i tryed to fly i crashed of course. after many blades and landing gear i go to the shop where i got it bent shaft, changed both inner and outer shaft made sure all blades were balanced sets, twisted every adjusting arm and screw on the thing and can't get it to fly. i either get the toilet bowl effect or it just flop over on the side. can't adjust the controller either. being a newbie i'm at a complete loss, have downloaded every little manuel and self help thing i can find and still nothing works. it's been in the top of the closet now for the last 6 months. anybody out there no what they are doing that can give me a hand


thanks

Jim

Mack66

Well, you've done so much to it, and it was apparently a while ago, I hesitate to give you a laundry list. Did you try calling tech support? They're very good at diagnosing things over the phone.

Another option is to take it to your local hobby store and ask them to look at it. There may be someone there with lots of experience. There's no doubt any one of us could sort it out if we had it in front of us.

Only time my CX2 would just "fall over" was when I had a swashplate separation. Tech support got on that right away. Soon as I snapped it back together, everything else started working and I could adjust the swashplate back to where it was in the first place.

I know this doesn't help much. Give tech support a chance to help you. You can even leave your number and they will call back so you don't have to wait around listening to elevator music, or repeating messages.

Mack

jimbo56

thanks mack. i have called tech on several occassions they sent me thru the elementary stuff again and again. what i am looking for hopefully is someone in my area tyler tx who might be able to together and see what we can come up with. but again thank you.