Tools needed
 

Am about to start building a Raptor 30 V2 from scratch.

What tools will I need to successfully complete this project.

Is there a tool that you have that you couldn't do without.

By sorting this out first I aim to reduce the build time (i.e not having to pop out and get extra tools to complete each part)

Look forward to receiving your replies

Tools needed
 

For one CA (glue)-Epoxy or JB Weld which ever required for clutch liner adhesion
LockTite (must)-For any nut or bolt that does not have the nylon insert to prevent loosening.
Phillps screw driver larger bit & Auger small sized
Allen Driver Set
Ruler I use mm
Needle Nose Pliers
Scissors For Decal if used
Nut Drivers

You will need a blade balancer & pitch gauge, you might could borrow these from another flyer.
Ball Link Pliers are a huge plus....

Tools needed
 

Thanks Culverson..

Will pop out and get myself those listed asap.

Cheers