RCU Forums - Esky Lama v3 trimming problems

RCU Forums (https://www.rcuniverse.com/forum/)

- RC Helicopter Beginners Forum (https://www.rcuniverse.com/forum/rc-helicopter-beginners-forum-165/)

- - Esky Lama v3 trimming problems (https://www.rcuniverse.com/forum/rc-helicopter-beginners-forum-165/9291237-esky-lama-v3-trimming-problems.html)

Matt90

11-30-2009 02:19 AM

Esky Lama v3 trimming problems

Hey I am new to this forum and I have a lama v3. Whenever I fly it the tail always spins to the right so I fixed the trim all the way over to the right, it is better but it still moves to the right slowely. Any suggestions
Cheers Matt

tecboy

12-03-2009 02:46 PM

RE: Esky Lama v3 trimming problems

Check the gears and the shafts. They maybe lose. It's happened to me before.

Matt90

12-04-2009 12:20 AM

RE: Esky Lama v3 trimming problems

Thanks for the help I will have a look, and also there are two screws on the 4in1 control unit, would these help.
Cheers Matt

tecboy

12-04-2009 10:21 PM

RE: Esky Lama v3 trimming problems

The two flat screws have already adjusted in the factory setting. Check the gears and shaft, first. Then, you can adjust the motor ratio and gyro gain.

Matt90

12-05-2009 03:28 PM

RE: Esky Lama v3 trimming problems

I turned the screw on the 4in1 about 1//20 of a turn and now it is flying great.

All times are GMT -8. The time now is 09:05 AM.