Fuel system
08-04-2003 | 10:32 PM
#1
Thread Starter
Junior Member
Joined: Jun 2003
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
From: baton rouge
Fuel system
Grettings fellow heli pilots
Anyone have any thoughts on optimal fuel line sizes for .60 or .70 sized engines?
Is 1/8" sufficient, or would 5/32" be a better choice? I would imagine flow vs. pressure would be a factor.
Or am I just splitting hairs?
richard
Anyone have any thoughts on optimal fuel line sizes for .60 or .70 sized engines?
Is 1/8" sufficient, or would 5/32" be a better choice? I would imagine flow vs. pressure would be a factor.
Or am I just splitting hairs?
richard
08-05-2003 | 12:01 AM
#2
Thread Starter
Junior Member
Joined: Jun 2003
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
From: baton rouge
Fuel system
Also; regarding the uniflow system;
Does the exaust pressure going into the bottom of the fuel tank cause bubbles in the fuel?
How is this arrangement better than the exaust pressure going in at the top of the tank?
Would the pressure be the same at the top vs. the bottom?
thanks,
richard
Does the exaust pressure going into the bottom of the fuel tank cause bubbles in the fuel?
How is this arrangement better than the exaust pressure going in at the top of the tank?
Would the pressure be the same at the top vs. the bottom?
thanks,
richard
