Here's what happen. I was playing with my JR 8103 and by mistake I changed my Ergo program(heli) to acro and when I switched it back I found that I had lost all my heli programing(*****). So I started to put everything back in it but the problem is I can't get my heading hold to work. It works great in normal mode but I can't get it to go into heading hold. When I go into stunt 1 ( it should be hh) but it's not. It acts like it is still in normal mode only the servo is a little slower. If I move my stick all the way to one side and release it the servo should stay there(when it is in hh) but it dosen't. WHY? what am I doing wrong? Thanks guys

P.S This gyro worked great be for I lost my programing

Check your gain settings while in hh it sounds like it is to low causing the gyro not to hold.
Just my 2 cents