Since it's too cold to fly I've been going through my Evo 50 checking everything. I just spent the last few hours pulling the engine and dial indicating the flywheel, fan and start shaft like everyone says you're supposed to do with your heli (I originally built the heli last July). I didn't see anything that was even a full thousandth out! I then checked the flywheel/fan for balance and didn't see anything worth messing with there either. This is the first time I've gone through a heli like this. I don't know about the others I've had but the Evo 50 certainly doesn't need any special attention to assemble the drive train.


Mike


P.S. I didn't have any excessive vibration, just wanted to make sure it's as good as I can make it.