JR Ergo 46 CCPM 3D-Blade Replace
06-22-2005 | 09:33 AM
#1
Thread Starter
Member
Joined: Sep 2004
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
From: Rosario-Santa Fe, ARGENTINA
JR Ergo 46 CCPM 3D-Blade Replace
Hi all
I like to replace the original wood blade of my JR Ergo 46 for other standart wood. This one has 560 mm. Could 550 mm st. wood blade working fine in it?. Or I should must cut the 600 mm wood to 560mm?. I can´t to use the 600 mm blade because the tail is short for it
The original blade has more wide than the standart 550 mm .
Thank in advance, and sorry for my English.
Gabriel
I like to replace the original wood blade of my JR Ergo 46 for other standart wood. This one has 560 mm. Could 550 mm st. wood blade working fine in it?. Or I should must cut the 600 mm wood to 560mm?. I can´t to use the 600 mm blade because the tail is short for it
The original blade has more wide than the standart 550 mm .
Thank in advance, and sorry for my English.
Gabriel
