SETUP AIRSKIPPER 50
01-16-2007 | 05:35 PM
#1
Thread Starter
Senior Member
Joined: Jan 2006
Posts: 227
Likes: 0
Received 0 Likes
on
0 Posts
From: Floro, NORWAY
SETUP AIRSKIPPER 50
Hi
I have just bought one J.R. Airskipper 50 with an O.S hyper 50. I will put on Funtech 600mm blades and a GY401. Anyone tested this combination before? I am aiming for beginner 3D level flying + general flying like inverted hover, loops, rolls etc. What can I expect from this chopper compared to e.g. Raptor? Any particular issues regarding building and setup?
Seems like this chopper is starting to get popular in Europe...
B.E
I have just bought one J.R. Airskipper 50 with an O.S hyper 50. I will put on Funtech 600mm blades and a GY401. Anyone tested this combination before? I am aiming for beginner 3D level flying + general flying like inverted hover, loops, rolls etc. What can I expect from this chopper compared to e.g. Raptor? Any particular issues regarding building and setup?
Seems like this chopper is starting to get popular in Europe...
B.E
01-23-2007 | 04:30 AM
#2
Senior Member
Joined: Sep 2005
Posts: 228
Likes: 0
Received 0 Likes
on
0 Posts
From: tasmania, AUSTRALIA
RE: SETUP AIRSKIPPER 50
I haven’t fly d a air skipper but the set-up you say sounds pretty good.
i have seen air skippers before and they look like a very nice heli i would like to get one myself.
i really don’t recon you will have any problems with your air skipper with that set up it should fly really well after you get it all program.
i have seen air skippers before and they look like a very nice heli i would like to get one myself.
i really don’t recon you will have any problems with your air skipper with that set up it should fly really well after you get it all program.
