Trouble programming quark 33a esc
09-24-2007 | 09:45 PM
#1
Thread Starter
Member
Joined: May 2007
Posts: 97
Likes: 0
Received 0 Likes
on
0 Posts
From: , NC
Trouble programming quark 33a esc
HEYA GUYS. I was just trying to program my Quark. I do as it says
1. Power on TX
2. Press programm button
3. Power on BEC switch
4. release program button after 1-2 seconds.
4. wiggle the throttle stick
But all i get is a red LED blinking. Im not getting any AUDIO indication and no single RED LED BLINK that says the ESC reconizes my TX (im using a dx-7)
If anyone can help me out i'd appreciate it
1. Power on TX
2. Press programm button
3. Power on BEC switch
4. release program button after 1-2 seconds.
4. wiggle the throttle stick
But all i get is a red LED blinking. Im not getting any AUDIO indication and no single RED LED BLINK that says the ESC reconizes my TX (im using a dx-7)
If anyone can help me out i'd appreciate it
