Quick .30 to scale airwolf?
04-04-2003 | 02:50 PM
#1
Thread Starter
My Feedback: (9)
Joined: Jan 2003
Posts: 455
Likes: 0
Received 0 Likes
on
0 Posts
From: Reading, PA
Quick .30 to scale airwolf?
Anybody know if this is possible. If anybody has a Century 30 size airwolf kit, what is the measurement from the main shaft to tail shaft (center to center?).
Thanks. I've been looking over the hawk and falcon mechanics that Century recommends for their scales... I just don't want to loose all the upgraded parts on my Quick, with a OS 46.
Thanks. I've been looking over the hawk and falcon mechanics that Century recommends for their scales... I just don't want to loose all the upgraded parts on my Quick, with a OS 46.
07-01-2003 | 09:21 AM
#4
Thread Starter
My Feedback: (9)
Joined: Jan 2003
Posts: 455
Likes: 0
Received 0 Likes
on
0 Posts
From: Reading, PA
Quick .30 to scale airwolf?
I actually decided to start easier. I went ahead and got a Bell Ranger kit, to wrap around one of the two listed helicopters. Then it got too nice out, and I didn't want to take apart the Quick.
I have sort of put off scale building until winter.
The Bell Ranger will have to sit with the unbuilt P-51 that I am working on.
-=Adam
I have sort of put off scale building until winter.
The Bell Ranger will have to sit with the unbuilt P-51 that I am working on.
-=Adam
