Servo chatter/buzz after replacing gears???
04-19-2008 | 03:17 AM
#1
Thread Starter
Junior Member
Joined: Feb 2007
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
From: san diego,
CA
Servo chatter/buzz after replacing gears???
Hi All,
I just replaced stripped gears on my JR 285's and I had to reset the pot post that holds the gear with the stopper on it. I turned it until the motor stopped spinning and reaassembled the gears. Problem is that no matter what, I could not get it to completely stop so now I have chatty servos. Any fixes???
Thanks
I just replaced stripped gears on my JR 285's and I had to reset the pot post that holds the gear with the stopper on it. I turned it until the motor stopped spinning and reaassembled the gears. Problem is that no matter what, I could not get it to completely stop so now I have chatty servos. Any fixes???
Thanks
