Post link!!! Help! Blade pitch
12-06-2009 | 01:12 PM
#1
Thread Starter
Member
Joined: Dec 2009
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
From: Cullman, AL
Post link!!! Help! Blade pitch
Can someone please post a link of a page showing how to adjust blade pitch for a cp pro 2. My heli's a bit off after changing the main shaft. Thanks guys!!!
12-14-2009 | 12:22 PM
#2
Senior Member
Joined: May 2009
Posts: 256
Likes: 0
Received 0 Likes
on
0 Posts
From: Savannah, GA
RE: Post link!!! Help! Blade pitch
If you're talking about adjusting the pitch of one rotor blade to make it match the other, you just change the length of the connector link to change the pitch angle of one of the blades.
Here's a link describing setting up generic CP, should help with yours. I think what your looking for is in the CCPM setup section.
http://www.helifreak.com/showthread.php?t=41692
Let us know if this helps?
Here's a link describing setting up generic CP, should help with yours. I think what your looking for is in the CCPM setup section.
http://www.helifreak.com/showthread.php?t=41692
Let us know if this helps?
