Engine cutting out
07-14-2003 | 05:28 PM
#1
Thread Starter
Junior Member
Joined: Jun 2003
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
From: Kilkenny, Ireland
Engine cutting out
I have an Irvine .36 engine that keeps cutting out when i remove the glow plug. The engine runs fine with the glow plug attached.
Is there a problem with my mixture (too lean or too rich).Heli is a Concept 30 sr-t
Is there a problem with my mixture (too lean or too rich).Heli is a Concept 30 sr-t
07-26-2003 | 05:33 AM
#5
Junior Member
Joined: Aug 2002
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
From: Australia, New South Wales
Engine cutting out
Try a hotter plug
I recommend an Enya#3 or OS#8.
Both have become the standard plugs in heli engines.
If this does not cure it then you are either too rich or your throttle trim just doesn't open the carby far enough.
I recommend an Enya#3 or OS#8.
Both have become the standard plugs in heli engines.
If this does not cure it then you are either too rich or your throttle trim just doesn't open the carby far enough.
