Old BVM Hot O Ring seals
10-20-2011 | 02:37 PM
#1
Thread Starter
Old BVM Hot O Ring seals
Hi guys
Can any of the BVM experts out there help me with the specifications of the Hot ORing Seal, part numer 5741, that was used in the BVM 82 engine (not the 91 or 96).
I need the width, inside and outside diameter so that I can order them at McMaster.
Regards
Eduardo
Can any of the BVM experts out there help me with the specifications of the Hot ORing Seal, part numer 5741, that was used in the BVM 82 engine (not the 91 or 96).
I need the width, inside and outside diameter so that I can order them at McMaster.
Regards
Eduardo
10-22-2011 | 03:41 AM
#4
Senior Member
Joined: Jul 2002
Posts: 434
Likes: 0
Received 0 Likes
on
0 Posts
From: coral springs,
FL
RE: Old BVM Hot O Ring seals
ORIGINAL: ECalderon
Hi guys
Can any of the BVM experts out there help me with the specifications of the Hot ORing Seal, part numer 5741, that was used in the BVM 82 engine (not the 91 or 96).
I need the width, inside and outside diameter so that I can order them at McMaster.
The good old days of DF, used many myself. can't help you with the size but make sure you get Viton, not rubber or silicone. Viton holds up to the heat better
Regards
Eduardo
Hi guys
Can any of the BVM experts out there help me with the specifications of the Hot ORing Seal, part numer 5741, that was used in the BVM 82 engine (not the 91 or 96).
I need the width, inside and outside diameter so that I can order them at McMaster.
The good old days of DF, used many myself. can't help you with the size but make sure you get Viton, not rubber or silicone. Viton holds up to the heat better
Regards
Eduardo
