Anyone know how to reset this thing?

On his site, Dan only talks about resetting the sequencer Plus, not the regular one. And I tried doing what he recommends and it didn't work.

Thanks!

Nobody??!!

OK, well, I found a thread where someone used a jetcat ECU to set the channel they wanted to use to set the ATV parameters so that the ECU registered an output between 1100-1800 and then the sequencer would work.

I'll try to call Dan at details for scale and post what he says.

give Dan a call

Ok, so even Dan had it somewhat wrong, but he helped!!

With the TX, RX and standard sequencer on. Press BOTH SW1 and SW2 then turn off RX while keeping both SW1 and SW2 pressed, turn the RX back on and it will reset.

Hold both buttons down and turn on the receiver, don't hold long. As soon as the receiver comes on, release immediately.

Richard