Hello

I got the new unit from RCBEE for the electric LG in my FeiBao T-33, but I don't get it working.
If I connect the batterie (2S LiPo) there is only for a few seconds RCBEE to read and than nothing more.

Is there any manual, available?

Christian

Hi

I have just received the instructions from FB, send me your email address and I will attach a copy for you, they do lose a bit of info in the translation though.

Regards
Peter

Christian

I have had several of these units, and have not had any problems with any. I see you are using 2s Lipo. This is too high voltage and you may have damaged it. The specified voltage is 3.5 to 6.5 v.

http://www.greathobbies.com/manuals/...001_manual.pdf

This is the jl version o the manual. It is the same as my Rcbee one. I cannot seem to be able to open rcbee web site at the moment.

John

Hi John

The new RCBee controller is a little different from the JL one you depict, it requires 7.4 volts and has an integrated screen display, I will try and upload a photo to show you. No sorry RCU photo is not working (again).

Regards
Peter

Hi all and for all,

the unit works fine.

My mistake was, I didn't connect the brake cabel with the receiver.
Only when gear and brake are connected with the receiver and power is on (receiver and additional unit power), the display is on.

The rcbee unit is different to the JL unit.
rcbee needs 2S LiPo.

Thank's for help

Christian

Christian

Glad you sorted your problems out.

I had not realised you were talking about the new electronic system.

http://www.rcbee.com/index.php?Page=19

Here is the link to the manual .

http://www.rcbee.com/downloads/EGC_rcbee.pdf

John

Hi John,

I have this manual .
But the problem is, there is no written, that you have to connect both receiver cables to get the unit working.

Christian