Hello all. I am going to convert a RAM 750 from the OEM RAM ECU to a new Xicoy ECU for a friend in our model club. I have done this conversion on a few other engines but not on a RAM. I was wondering if anyone has done this conversion and if so could you provide the engine programming parameters that you found to work. I am thinking about stuff like fuel ramp, engine starter reconnect, engine starter disengage, accel and decel delay. Any help would be greatly appreciated.

Thanks in advance,
Ed

Ed

On the Ram conversions I did. I started with the stock settings. I think all I set was low rpm, High rpm, and adjusted the start up till I had the least amount of flame.

Send me a pm is you need more..

Clay

Thanks Clay. Hope all is well with you. Will PM if I have problems. My plan was to do as you did and just start with the setting from a gas start engine I have and "sneak up" on the finals settings.

Ed