I started my AMT Mercury today and all was well with the engine data terminal. After flying I did a shut-down I noticed that the EDT just had two solid lines if data....No discernable numbers or letters, just solid blocks for two lines. I changed the battery for a fresh one and the same thing. Do I have a bad connection or did my EDT give up the ghost????

Kevin

Ive heard of that happening once before something had happened to the circuit board (as i recall)possibly a short. Give Scott a call tomorrow (fri Jan16th) if you can. I'll tell him whats going on when i get there in the morning.

Rodney Evans ~ AMT-USA ~ Factory Engine Assembler

(304)375-3777 7:30am - 4:00 pm EST Mon-Fri

Same thing happened to mine Kevin...had to be sent back....something had to be re-tweaked on the circuit board....I don't think they had to replace anything....

Tom

If I want to buy a AMT and install is into a CAI-Razor?, What tips, type turbine used and the Most! important question. Where do I get the CAI Razor?, web-site?

Thanks,
I have been out for 3 years and do not see any CAI info at this site.
Regards,
GF

Thanks Rodney and Tom....I've gotten used to using the EDT and like to monitor what is going during start-up and shut-down. I didn't get this message until late Friday afternoon. I'll give them a call on Monday.

Kevin