Model Mechanics trunion
04-23-2006 | 11:19 PM
#1
Thread Starter
My Feedback: (100)
Joined: Nov 2002
Posts: 198
Likes: 0
Received 0 Likes
on
0 Posts
From: Ligonier IN
Model Mechanics trunion
Does anyone have a couple of Model mechanics 1/2 trunions laying around or know where I can buy a couple of new replacements? Had a slight depth perception problem and my Roo ended up on the sand instead of blacktop. Kind of puts a strain on the gear to go from 35mph to stop in 2 feet. Both mains said "no way". Can Robart trunions be made to fit, they look very close.
04-25-2006 | 06:57 AM
#2
My Feedback: (24)
RE: Model Mechanics trunion
sprockett,
I tore the gear out of my Eurosport at the end of the last season and decided to switch to Robart. I have a set of MM trunions that I could take out of the old gear and send to you. Send me a PM with your address and I'll get them in the mail this weekend...
Bob
I tore the gear out of my Eurosport at the end of the last season and decided to switch to Robart. I have a set of MM trunions that I could take out of the old gear and send to you. Send me a PM with your address and I'll get them in the mail this weekend...
Bob
04-25-2006 | 08:32 AM
#3
Senior Member
Joined: Sep 2003
Posts: 308
Likes: 0
Received 0 Likes
on
0 Posts
From: Johannesburg, SOUTH AFRICA
RE: Model Mechanics trunion
Hi Sprockett
If you don't come right, send me a PM and I will pick up a set for you from the factory and send them to you. I will be away for about a week from tomorrow so I might no respond immediately.
I don't think that the Euro ones are the same. They are bigger than the Roo ones.
Cheers
Zane
If you don't come right, send me a PM and I will pick up a set for you from the factory and send them to you. I will be away for about a week from tomorrow so I might no respond immediately.
I don't think that the Euro ones are the same. They are bigger than the Roo ones.
Cheers
Zane
