today I was trying to do some taxi testing done on my super hornet. Range check good no fades holds ECT ECT. Plug the gsu into the turbine to program it which I believe its done I could not get past the full expo half expo linear option. When I hit the plus to accept it would just change from full to half expo and then linear. So tring to start its ready then starts flashing

Rc signal
lost/incorrect

The rx errors page and its steadily counting up to 9999 and starts over. I checked the extension to the rx to the ecu and it looks like its pluged in right. This is a 2.4 system. Any ideas guys. Anything obvious i am forgetting

Thanks.

David

Did you get through the learn RC menu or did this happen after the initial programming?

Yes I got through the programing of the radio because it would respond to my trim settings trim low and ready

David

What type of batteries are you using for the ECU? I think I had a message like that once when I was trying out two cell A123's.

Marty