Peter Coers

One half of the tail mold is ready.





The first elevator part in 2k primer.

invertmast

My Feedback: (23)

Looking good peter!

Peter Coers

Thanks Thomas .

Peter Coers

One side to go.

Peter Coers

The belly of the 16 is ready for lots of epoxy .

Peter Coers

And it is blue

FenderBean

It amazes me what some people can do in their house, good work.

Peter Coers

Me too , so the right belly is molded now.





over to the next side.

argyris

Greart work dear Peter!!!How is your legs? My shinden take 10 hours molding each side.

Peter Coers

, Legs oke back a bit less . I did 7 layers in 5 hours and ended with peelply so 8 layers total. Also stopped in between to eet something.
The gellcoat and two other layers I did earlyer, also covered with peelply.

invertmast

My Feedback: (23)

5 hours, thats nothing! The bottom center section mold of the F14 took 21 hours, start to finish!

Peter Coers

In one run Thomas? your 14 needs big slices of cltoh haha, my 16 is a little tube compared with your's.

invertmast

My Feedback: (23)

Yep, all one run. I think i went through around 50-60 yards of cloth for the fuselage mold

Peter Coers

Now I know why you were fed up with the project .
Keep it going!

invertmast

My Feedback: (23)

Haha. Yup! I could of bought a skymastee F14 and gotten it flying with the amount i have invested in mine so far.

The good news is, i only have the slat molds to do and the airframe is done, after that its all detail parts and molds.

Peter Coers

We both have a lot of time in the projects but we can say we made it OUR SELVE! There are very few full alu sheeted jets on this planet .

invertmast

My Feedback: (23)

Very true! And yours is Much nicer than mine

Peter Coers

I think with some tlc and sanding the final outcome of your's will look fantastic just like the real one.

Peter Coers

It is closed .......... almost. Last part tomorrow, underside nose section.

Peter Coers

Last part of the fuse....

Peter Coers

Polled the fuse over, it's heavy . After the weekend I will open the mold .

FenderBean

Peter, I know your super excited! I know I asked you this before do you plan on selling any kits?

Peter Coers

That is the intention when all goe's right with testing etc etc, it can take a while.

invertmast

My Feedback: (23)

Your doing better time wise than i am! It looks great Peter. Heavy is probably an understatement

Peter Coers

The nose is out of the mold , and came out good.